Warning: Some posts on this platform may contain adult material intended for mature audiences only. Viewer discretion is advised. By clicking ‘Continue’, you confirm that you are 18 years or older and consent to viewing explicit content.
PETG and ABS are easily the most used materials in my prints. I like their properties. But I enjoy ABS only after completing my Voron 2.4 to be honest even though that’s not strictly a requirement.
I just started messing around with ASA on my i3 clone (Monoprice maker select plus aka wanhao i3 plus) while printing parte for my 2.4. I did make a cardboard enclosure for my printer and had to reprint my bed thumbscrews and cooler in ASA, but otherwise it pretty well. I treated it the exact same as PETG, other than bumping temps. I was honestly pretty surprised. Yeah, the prints aren’t perfect, but I also spent zero time tuning the printer for ASA beyond a PID tune.
PETG and ABS are easily the most used materials in my prints. I like their properties. But I enjoy ABS only after completing my Voron 2.4 to be honest even though that’s not strictly a requirement.
I just started messing around with ASA on my i3 clone (Monoprice maker select plus aka wanhao i3 plus) while printing parte for my 2.4. I did make a cardboard enclosure for my printer and had to reprint my bed thumbscrews and cooler in ASA, but otherwise it pretty well. I treated it the exact same as PETG, other than bumping temps. I was honestly pretty surprised. Yeah, the prints aren’t perfect, but I also spent zero time tuning the printer for ASA beyond a PID tune.