Warning: Some posts on this platform may contain adult material intended for mature audiences only. Viewer discretion is advised. By clicking ‘Continue’, you confirm that you are 18 years or older and consent to viewing explicit content.
Yep, not usually safe to reuse your prints or put them in heat or get them wet, but for a single batch of cookies the risk of a 3d printed cookie cutter is pretty minimal.
Rockin’.
INB4 you get crucified for FDM prints not being “food safe.” …I might just be having flashbacks to that time spent at the other place, though.
I use fdm prints for food all the time. Just use once and throw away. As long as you use steel nozzle I think it’s fine no lead dangers.
Yep, not usually safe to reuse your prints or put them in heat or get them wet, but for a single batch of cookies the risk of a 3d printed cookie cutter is pretty minimal.
My wife did me a favor and soaked all my pla cookie cutters in super hot water to get them clean.
I print with PETG and run them through the dishwasher.
If I vapour smooth it with acetone, would be safe then?