Warning: Some posts on this platform may contain adult material intended for mature audiences only. Viewer discretion is advised. By clicking ‘Continue’, you confirm that you are 18 years or older and consent to viewing explicit content.
Por que no just fuse them together in your slicer and print as a monolithic part? You could probably even skip the base and just arrange the four bins together.
I wouldn’t do that in the slicer, it’s too hard to align them. I don’t know about any alignment tools in slicers. I could do that in Fusion360, however.
Por que no just fuse them together in your slicer and print as a monolithic part? You could probably even skip the base and just arrange the four bins together.
I wouldn’t do that in the slicer, it’s too hard to align them. I don’t know about any alignment tools in slicers. I could do that in Fusion360, however.
There are various tricks I could think of, but in Slic3r/Prusa/Orca/etc. I think I would just do an auto arrange on them with the spacing set to zero.