Warning: Some posts on this platform may contain adult material intended for mature audiences only. Viewer discretion is advised. By clicking ‘Continue’, you confirm that you are 18 years or older and consent to viewing explicit content.
That’s a very good question. I’ve been killing the edge on knives since it was first explained (by the president of Shapton US) that it is a “good idea” to remove any fatigued metal at the apex before building a final, finished edge. He’s an avid woodworker, so he called this jointing the edge. I have not, ever, seen analysis that would support fatiguing at the edge. It’s plausible, but I kind of doubt that collisions with surface abrasives that remove metal are leaving metal there long enough for it to fatigue significantly. I do this more because I feel that it “can’t hurt”, than I feel that it has structural merit. I often forget to kill the edge both on knives and razors, and I have yet to discern a difference.
That’s a very good question. I’ve been killing the edge on knives since it was first explained (by the president of Shapton US) that it is a “good idea” to remove any fatigued metal at the apex before building a final, finished edge. He’s an avid woodworker, so he called this jointing the edge. I have not, ever, seen analysis that would support fatiguing at the edge. It’s plausible, but I kind of doubt that collisions with surface abrasives that remove metal are leaving metal there long enough for it to fatigue significantly. I do this more because I feel that it “can’t hurt”, than I feel that it has structural merit. I often forget to kill the edge both on knives and razors, and I have yet to discern a difference.