Warning: Some posts on this platform may contain adult material intended for mature audiences only. Viewer discretion is advised. By clicking ‘Continue’, you confirm that you are 18 years or older and consent to viewing explicit content.
Got it set up and printed a little trinket I’d made for my wife earlier, that on the CR-10 printed in about 27 minutes; took a flat 13 on the K1 and that was with a very conservative 7500 mm/min. I’m excited to see what this can push up to!
Ah, yes - the Cartesian to CoreXY swap. At a certain point you might want to consider a bigger nozzle. Yeah, physically moving faster is nice, but being able to go from say 4 walls to 2, while keeping the same wall thickness and without a time hit, is great.
Got it set up and printed a little trinket I’d made for my wife earlier, that on the CR-10 printed in about 27 minutes; took a flat 13 on the K1 and that was with a very conservative 7500 mm/min. I’m excited to see what this can push up to!
Ah, yes - the Cartesian to CoreXY swap. At a certain point you might want to consider a bigger nozzle. Yeah, physically moving faster is nice, but being able to go from say 4 walls to 2, while keeping the same wall thickness and without a time hit, is great.