Warning: Some posts on this platform may contain adult material intended for mature audiences only. Viewer discretion is advised. By clicking ‘Continue’, you confirm that you are 18 years or older and consent to viewing explicit content.
Misconvergence and geometry in general is really only a problem with low end models or large tubes.
From the 1980’s to 1990’s I had a 13" Seiko Trinitron, then a Mag 15", then ViewSonic 17". None were low end. All had misconvergence and geometry problems at their highest resolution.
If you only game on it you’ll never notice. But I coded and played with CAD for fun. There was no adjustment, even with opening up and adjusting the tube chokes (which I did) that could get every corner perfectly converged and have absolutely perfect straight lines on all sides simultaneously.
From the 1980’s to 1990’s I had a 13" Seiko Trinitron, then a Mag 15", then ViewSonic 17". None were low end. All had misconvergence and geometry problems at their highest resolution.
If you only game on it you’ll never notice. But I coded and played with CAD for fun. There was no adjustment, even with opening up and adjusting the tube chokes (which I did) that could get every corner perfectly converged and have absolutely perfect straight lines on all sides simultaneously.
Software compensation does exist, if you want to give it a blast
You can simulate misconverged pixels with filters but I don’t see how the reverse is possible in software. Could you link to the software?