Warning: Some posts on this platform may contain adult material intended for mature audiences only. Viewer discretion is advised. By clicking ‘Continue’, you confirm that you are 18 years or older and consent to viewing explicit content.
I’m not sure what orientation you’re printing it at but you could try organic supports, those usually take up less surface area. Unfortunately with supports you’re always going to have a rougher surface than printing without them
I’m not sure what orientation you’re printing it at but you could try organic supports, those usually take up less surface area. Unfortunately with supports you’re always going to have a rougher surface than printing without them
Also in this case it might make sense to split the model, then glue it together.