Warning: Some posts on this platform may contain adult material intended for mature audiences only. Viewer discretion is advised. By clicking ‘Continue’, you confirm that you are 18 years or older and consent to viewing explicit content.
You are too close everywhere. Im not using abl, but dont expect perfection from it. I believe if you increase offset it will be good everywhere. Machine can deal with small error, but not if its too much
When my Ender 3 S1 (not plus) had bed leveling issues, the problem was caused by backlash on the Z axis. It’s important that the Z axis be just loose enough that downward motion is driven by gravity. If instead the Z screws have to “pull down” on the gantry, then the height will be too sloppy for ABL to make fine adjustments.
I’m agree! But look at my picture, how can it be good at some point, and to close at others?
You are too close everywhere. Im not using abl, but dont expect perfection from it. I believe if you increase offset it will be good everywhere. Machine can deal with small error, but not if its too much
Tank you!
When my Ender 3 S1 (not plus) had bed leveling issues, the problem was caused by backlash on the Z axis. It’s important that the Z axis be just loose enough that downward motion is driven by gravity. If instead the Z screws have to “pull down” on the gantry, then the height will be too sloppy for ABL to make fine adjustments.