Warning: Some posts on this platform may contain adult material intended for mature audiences only. Viewer discretion is advised. By clicking ‘Continue’, you confirm that you are 18 years or older and consent to viewing explicit content.
If the printer is fully enclosed (door and lid closed) and the print is long enough. The heat from the hotend and bed can build up in the chamber, causing heat creep. The chamber temperature is not monitored. Since the nozzle and heatbreak are one piece, removing the clog is a bit more involved.
I’ve had to do it 3 times since I bought the printer on release. All were 12+ hour PLA prints and done after high temperature filament prints (nylon and abs).
The issue is entirely preventable, just me forgetting to open the door on long prints lol.
I mostly print PLA so the lid is propped open and the door is ajar… Once winter comes to the midwest and my basement is freezing cold I may have to adjust things a bit. I added a Prusa MINI in January 2022 and could not print properly until I added an enclosure.
If the printer is fully enclosed (door and lid closed) and the print is long enough. The heat from the hotend and bed can build up in the chamber, causing heat creep. The chamber temperature is not monitored. Since the nozzle and heatbreak are one piece, removing the clog is a bit more involved.
I’ve had to do it 3 times since I bought the printer on release. All were 12+ hour PLA prints and done after high temperature filament prints (nylon and abs).
The issue is entirely preventable, just me forgetting to open the door on long prints lol.
I mostly print PLA so the lid is propped open and the door is ajar… Once winter comes to the midwest and my basement is freezing cold I may have to adjust things a bit. I added a Prusa MINI in January 2022 and could not print properly until I added an enclosure.