Warning: Some posts on this platform may contain adult material intended for mature audiences only. Viewer discretion is advised. By clicking ‘Continue’, you confirm that you are 18 years or older and consent to viewing explicit content.
I used to have issues with like rpmfusion repos and the like, worst case you may need to now the packages you have layered, do an rpm-ostree reset, upgrade, then layer the packages again. There’s a way to install the rpmfusion repos that didn’t break updates, I forget if they’ve updated the docs on the site to use it, I stopped layering almost everything in favor of flatpak or toolbx.
I just did it. You’re in for a reboot. That’s about it, unless you layered a bunch of stuff.
It won’t matter of you layered a bunch of stuff
It will if the repos are specific to a fedora release version. That’s been a thing with rpmfusion in the past, not sure it still is.
If you are using the officially supported repos you are fine. If are not using official repos I would strongly suggest that you do.
Any external software should be installed in a container (ideally) or in a VM.
I maaaay have layered some stuff that I couldn’t find flatpaks for. 🥺
I used to have issues with like rpmfusion repos and the like, worst case you may need to now the packages you have layered, do an rpm-ostree reset, upgrade, then layer the packages again. There’s a way to install the rpmfusion repos that didn’t break updates, I forget if they’ve updated the docs on the site to use it, I stopped layering almost everything in favor of flatpak or toolbx.
I’ll keep your advice in mind. Thanks kind internet stranger. ✌🏻