Warning: Some posts on this platform may contain adult material intended for mature audiences only. Viewer discretion is advised. By clicking ‘Continue’, you confirm that you are 18 years or older and consent to viewing explicit content.
Yup, I have one device that’s stuck on 2.4GHz, my Brother laser printer. It works fantastically otherwise and it has an Ethernet port, but I haven’t bothered to run cable yet to it. I suspect a lot of people have that one device they’d rather not replace, which is still on an old wifi standard.
So I just make sure to have a simultaneous dual-band setup. Everything else uses 5GHz, and the 2.4GHz band exists for that one device, or if I’m on the opposite side of the house or something. I use fancy networking stuff though (Ubiquiti APs), your average person would just be confused at why the internet is sometimes slow (i.e. when the printer wakes up).
Yup, I have one device that’s stuck on 2.4GHz, my Brother laser printer. It works fantastically otherwise and it has an Ethernet port, but I haven’t bothered to run cable yet to it. I suspect a lot of people have that one device they’d rather not replace, which is still on an old wifi standard.
So I just make sure to have a simultaneous dual-band setup. Everything else uses 5GHz, and the 2.4GHz band exists for that one device, or if I’m on the opposite side of the house or something. I use fancy networking stuff though (Ubiquiti APs), your average person would just be confused at why the internet is sometimes slow (i.e. when the printer wakes up).
While my printer only supports 2.4GHz, it’s always been on Ethernet
But too many smart home devices and media streamers, even after making an effort to stick with local IoT meshes.