Warning: Some posts on this platform may contain adult material intended for mature audiences only. Viewer discretion is advised. By clicking ‘Continue’, you confirm that you are 18 years or older and consent to viewing explicit content.
In the case of zsh it will quite happily do either and ask you which you meant just like if they were called Dir1 and Dir2. Also works if you have a dir1 and Dir2 in the same directory as well
it depends on your shell configs. In my case it sits at dir/Dir (case insensitive) waiting for me to specify 1 or 2, where as if you disable it, it’s dependent on whether or not you type d or D.
If you have “Dir1” and “DIR2” and you type “cd d”, your prompt will look like in the next picture. Fish automatically transforms “d” into “D”, because there is no dir starting with the lowercase “d”.
On a subsequent <TAB> you’ll get a list of dirs matching your prompt so far in which you choose an entry with the cursor key and enter it with the enter key.
If I have two folders in my directory,
Dir1anddir2, what doesd <TAB>autocomplete to and what should it do?At least on zsh it would pop both of those as suggestions you can cycle through.
deleted by creator
In the case of zsh it will quite happily do either and ask you which you meant just like if they were called Dir1 and Dir2. Also works if you have a dir1 and Dir2 in the same directory as well
deleted by creator
it depends on your shell configs. In my case it sits at dir/Dir (case insensitive) waiting for me to specify 1 or 2, where as if you disable it, it’s dependent on whether or not you type d or D.
In fish it would immediately expand to dir2.
If you have “Dir1” and “DIR2” and you type “cd d”, your prompt will look like in the next picture. Fish automatically transforms “d” into “D”, because there is no dir starting with the lowercase “d”.
On a subsequent <TAB> you’ll get a list of dirs matching your prompt so far in which you choose an entry with the cursor key and enter it with the enter key.