Warning: Some posts on this platform may contain adult material intended for mature audiences only. Viewer discretion is advised. By clicking ‘Continue’, you confirm that you are 18 years or older and consent to viewing explicit content.
Onshape and Fusion360 both have tons of great tutorials available, and they are completely free for non-commercial use. There is a reason those are used by almost everyone in the 3d printing community.
“And they are completely free for non-commercial use.” I have seen both of their “community” or “maker” tiers get worse over time; the terms of those licenses becoming less permissive. I’ve been told by an Autodesk employee that it doesn’t exist for Fusion360. “There is no free software here.” I suggest against building anything that matters to you against those platforms.
Onshape and Fusion360 both have tons of great tutorials available, and they are completely free for non-commercial use. There is a reason those are used by almost everyone in the 3d printing community.
“And they are completely free for non-commercial use.” I have seen both of their “community” or “maker” tiers get worse over time; the terms of those licenses becoming less permissive. I’ve been told by an Autodesk employee that it doesn’t exist for Fusion360. “There is no free software here.” I suggest against building anything that matters to you against those platforms.
As long as you don’t need much, they are free. But, the good stuff is all pay to play.