Warning: Some posts on this platform may contain adult material intended for mature audiences only. Viewer discretion is advised. By clicking ‘Continue’, you confirm that you are 18 years or older and consent to viewing explicit content.
This is the official release of OrcaSlicer V2.1.0
This update includes minor fixes and new translations.
For a detailed list of all the new features, please refer to the release notes for v2.1.0 Be...
The UI of Prusa slicer is hot garbage though. I started with prusa slicer and moved to orca after a few months. Orca is a much nicer experience, and the built-in test-models (temp towers etc.) are nice.
In find the location and grouping of parameters more intuitive in orca. I always had to look through several tabs to find the parameter I wanted to adjust when I was using prusa, it was never where I thought it should be.
The UI of Prusa slicer is hot garbage though. I started with prusa slicer and moved to orca after a few months. Orca is a much nicer experience, and the built-in test-models (temp towers etc.) are nice.
I’m comparing cura and prusa, so prusa wins by a lot. What are you comparing prusa to? Orca?
Yes
I give orca/bambu the edge for “prettier on screenshots”, but in practice, I don’t find their UI paradigm to be more efficient nor convenient.
In find the location and grouping of parameters more intuitive in orca. I always had to look through several tabs to find the parameter I wanted to adjust when I was using prusa, it was never where I thought it should be.