Warning: Some posts on this platform may contain adult material intended for mature audiences only. Viewer discretion is advised. By clicking ‘Continue’, you confirm that you are 18 years or older and consent to viewing explicit content.
Zram usually has a very high compression ratio - around 4:1 for lz4 and 6:1 for zstd. You can set zram to 40-50 GB. It will still use less than 1/2 of your ram.
Zram has an option to write poorly compressible data to the disk instead of storing it in the ram. I would split the swap partition - 3 GB for zram writeback and rest for ordinary swap.
Oh, I think I might have thought zram was similar to swap, I didn’t realize it takes up ram. Is there a way to see how much ram it’s using? What do you think I should set my zram amount to(and how do I change the zram amount, I’m using zram-config)
Zram usually has a very high compression ratio - around 4:1 for lz4 and 6:1 for zstd. You can set zram to 40-50 GB. It will still use less than 1/2 of your ram.
Zram has an option to write poorly compressible data to the disk instead of storing it in the ram. I would split the swap partition - 3 GB for zram writeback and rest for ordinary swap.
Oh, I think I might have thought zram was similar to swap, I didn’t realize it takes up ram. Is there a way to see how much ram it’s using? What do you think I should set my zram amount to(and how do I change the zram amount, I’m using zram-config)
Zram is basically a compressed swap device located in your ram. You can check the usage by running zramctl.
I would recommend setting mem_limit to 10 GB or disk_size to 40GB and algorithm to lz4.
https://github.com/ecdye/zram-config#example-configuration
Which part is the usage?
This link says that configuration is stored in a file that doesn’t exist, should I make it?